Some installation precautions for wheel hubs

Please pay attention to the following matters in the use and installation of wheel hub bearings:

1. To ensure maximum safety and reliability, it is recommended that you regularly check the wheel hub bearings regardless of the age of the vehicle - paying attention to early warning signals of bearing wear, including any friction noise during rotation or abnormal deceleration of the suspension combination wheels during turning. For rear wheel drive vehicles, it is recommended to lubricate the front wheel hub bearings when the vehicle has traveled 38000 kilometers. When replacing the brake system, check the bearings and replace the oil seal.

2. If you hear noise coming from the hub bearing area, the first thing is to identify the location where the noise is occurring. There are many moving parts that may produce noise, and it is also possible that some rotating parts have come into contact with non rotating parts. If it is confirmed that the noise is from the bearing, the bearing may be damaged and needs to be replaced. 3. Because the working conditions for bearing failure on both sides caused by the front wheel hub are similar, even if only one bearing is damaged, it is recommended to replace it in pairs.

4. Wheel hub bearings are sensitive and require the correct method and appropriate tools in any situation. During storage, transportation, and installation, the components of the bearings must not be damaged. Some bearings require significant pressure to be pressed in, so special tools are needed. Please refer to the car manufacturing manual.

5. When installing bearings, they should be installed in a clean and tidy environment. Small particles entering the bearings can also shorten their service life. It is very important to maintain a clean environment when replacing bearings. Do not use a hammer to strike the bearing, and be careful not to drop the bearing on the ground (or handle it improperly). Before installation, the condition of the shaft and bearing seat should also be checked, as even minor wear can lead to poor fit and early failure of the bearings. 6. Do not attempt to disassemble the hub bearing unit or adjust the sealing ring of the hub unit, as this may damage the sealing ring and allow water or dust to enter. Even the sealing ring and the raceway of the inner ring are damaged, causing permanent failure of the bearing.

7. There is a magnetic thrust ring inside the sealing ring of the bearing equipped with ABS device, which cannot be subjected to collision, impact or collision with other magnetic fields. Before installation, remove them from the packaging box and keep them away from magnetic fields, such as electric motors or power tools used. When installing these bearings, observe the ABS warning needle on the dashboard through road condition testing to change the operation of the bearings.

8. A wheel hub bearing equipped with an ABS magnetic thrust ring can be approached with a lightweight object to determine which side the thrust ring is installed on. The magnetic force generated by the bearing will attract it. During installation, point the side with magnetic thrust ring inward, facing the sensitive component of ABS. Attention: Incorrect installation may cause the brake system to malfunction.

9. Many bearings are sealed and do not require lubrication throughout their entire lifespan. Other unsealed bearings, such as double row tapered roller bearings, must be lubricated with grease during installation. Due to the different sizes of the inner cavities of bearings, it is difficult to determine how much grease to add. The most important thing is to ensure that there is grease in the bearings. If there is too much grease, excess grease will seep out when the bearings rotate. General experience: During installation, the total amount of grease should account for 50% of the clearance between the bearings.

10. When installing the locking nut, the torque varies greatly due to the different types of bearings and bearing seats. Please refer to the relevant instructions.